ASSEMBLY INSTRUCTIONS FOR ELITE TABLE

Assembly is suggested with the presence/help of two people.

Use floor protection (thick cloth) to avoid damaging the floor itself and the dowels.

Do not remove the rubber protections from the dowels until the table is fully positioned.

Flip the tabletop and lay it on the ground on the long side with the frame facing upwards, using the dowels as supports.

Screw the legs onto the frame, making sure to use the unperforated thread. Screw firmly until there is full contact between the parts.

Insert the legs into the base through the 21mm holes until there is full contact between the parts.

Screw the tightening nuts through the 60mm hole using the provided tubular wrench until there is full contact between the parts.

Position yourself sideways to the table and grasp the dowel resting on the floor with one hand and the upper leg with the other, then flip the table into its final position.

The disassembly steps are obviously the same but in reverse.

Use floor protection (thick cloth) to avoid damaging the floor itself and the dowels.

To prevent accidental damage to dowels and floor, insert the provided rubber protections onto the dowels before starting the disassembly steps.

Position yourself on the short side of the table and grasp the dowel with one hand and the farthest leg with the other. Rotate the table, laying it on the long side using the dowels as supports.

Unscrew the nuts using the provided tubular wrench.

Gently remove the base.

Unscrew the legs using the provided stainless steel pin, inserting it into the hole on the leg’s thread and applying a counter-clockwise twist.